Timing belts with chain repair kits
- Ready-made kits for comprehensive vehicle maintenance and individual components
- All parts are identical to the original ones and are made using the best materials: high-strength steel, reinforced plastic
- Progressive manufacturing and processing technology provides unsurpassed resource and valve timing accuracy
- Resistance to work in an aggressive environment
LYNXauto timing chain repair components - chains, gears, sprockets, pulleys, tensioners, guides, etc. are produced on high-precision modern equipment using the most advanced technologies and the highest quality materials.
Сhains and gears are made of high-strength steel with subsequent heat treatment.
Chain tensioners are manufactured with the highest precision, which allows them to maintain minimum internal clearances and ensure the required chain tension, without noise and vibrations. Quality control of each item of manufactured products is carried out on test benches. Chain Driven Timing Repair Components deliver high performance, long service life and ensure efficient and reliable system and engine operation.
The LYNXauto timing valve is one of the key elements of modern engines with a variable valve timing system.
LYNXauto valves are manufactured on CNC machining centers with optical dimensional control. This allows you to achieve full compliance with the geometric parameters of OE parts, including precision surfaces involved in the seal. The LYNXauto control valve solenoid components are carefully inspected and tested to ensure precise control and long life.
High-quality oil and petrol resistant rubber provides reliable vibration dissipation throughout the entire service life (at least 80 thousand km) and in a wide operating temperature range (from -50°C to +200°C). High-quality cast iron FC150 with a hardness of 220HB guarantees high wear resistance of LYNXauto crankshaft pulleys. The designs of LYNXauto crankshaft pulleys are fully consistent with original parts. 100% of the pulleys are automatically balanced and have a radial runout tolerance of no more than 0.010 mm.
